Measuring - Pentax R-100 Serie Manual De Instrucciones

4.7 Measuring

Then, aim at the Target point and press the [F1][MEAS] to measure the distance.
Press [F3][ME/SAVE] to measure and save the measured data.
Press [F2][SAVE] to save the measured data.
Press [F4][EDIT] to edit the PN, Point Name, PH, Prism Height and PC, Point Code. Press the
[ENT] key to view each input window by pressing up or down arrow key, and input your desired
point name or prism height or point code. Press [F5][ACCEPT] if the current PN, PH and PC are
acceptable.
Press [F5][PAGE] to view another menu.
Station point setup can be changed by pressing [F3][STATION].
EDM settings can be selected by pressing [F1][EDM]
For example, change 1.PRIM. MEAS KEY (MEAS) to TRACK SHOT or TRACK CONT if you want to use
tracking measurement with primary MEAS key (MEAS).
MEASURE
PN POT3
PH 1.200 m
H.angle xxx° xx' xx"
V.angle xxx° xx' xx"
S.dst xx.xxx m
ME/SAVE
MEAS SAVE
MEASURE
1. PN: POT5
2. PH: 000.000 m
3. PC:
MEASURE
PN POT3
PH 1.200 m
H.angle xxx° xx' xx"
V.angle xxx° xx' xx"
S.dst xx.xxx m
OFFSET STATION
MEASURE
PN POT3
PH 1.200 m
H.angle xxx° xx' xx"
V.angle xxx° xx' xx"
S.dst xx.xxx m
EDM TARGET
STATION POINT SETUP
1. PN : XXXXX
2. IH : 000X.X00 m
3. TEMP : 27 C
4. PRESS : Can't be changed
5. ppm : 16 ppm
SAVE
EDM SETTINGS
1. PRIM. MEAS KEY : MEAS. SHOT
2. SEC. MEAS KEY : TRACK CONT
3. TRACK MIN DISP. : COARSE
4. SHOT COUNT : 1 TIME
5. SHOT INPUT : 01
28
EDIT PAGE
ACCEPT
PAGE
PAGE
ACCEPT
TIMES
ACCEPT