Sending Data Setting - Pentax R-100 Serie Manual De Instrucciones

COMM. SETTING SELECTION
1.BAUD RATE
2.DATA LENGTH
3.PARITY BITS
4.STOP BITS
5.SIGNAL CONTROL
Press [ACCEPT] key to enter when all selections are finished.
TRANS. COORD. AXIS: XYZ, YXZ, NEZ or ENZ is selected when data is transferred between the
TS and PC.
Factory default setting of RECEIVING
1.BAUD RATE:
2.DATA LENGTH:
3.PARITY BITS:
4.STOP BITS:
5.SIGNAL CONTROL:
6.XON/XOFF:
7.PROTOCOL:
8.RECORD DELIMETER: CR+LF
9.TRANS.COORD.AXIS:
9.3.2

Sending data setting

Select the 4. COMMUNICATION SETUP and press the [ENT] key to view the COMM. SETTING
SELECTION.
[2. SEND RECT. DATA]
Select the 2. SEND RECT. DATA and press the [ENT] key to view the following screen. Press the [ENT]
key to open the selection window.
Select each setting and press the [ENT].
COMM. SETTING SELECTION
1.BAUD RATE
2.DATA LENGTH
3.PARITY BITS
4.STOP BITS
5.SIGNAL CONTROL
Press [ACCEPT] key to enter when all selections are finished.
TRANS. COORD. AXIS: XYZ, YXZ, NEZ or ENZ is selected when data is transferred between the
TS and PC.
Factory default setting of SENDING
1.BAUD RATE:
1.1200
2.2400
1200
8
NIL
1
ON
ON
ON
XYZ
COMM. SETTING SELECTION
1. RECEIVE RECT. DATA
2. SEND RECT. DATA
3. SEND POLAR DATA
1.1200
2.2400
3.4800
4.9600
9600
COMM. SETTING SELECTION
4.STOP BITS
5.SIGNAL CONTROL
6.XON/XOFF
7.PROTOCOL
8.RECORD DELIMETER
9 TRANS COORD AXIS
COMM. SETTING SELECTION
1.BAUD RATE : 9600
2.DATA LENGTH : 8
3.PARITY BITS : NIL
4.STOP BITS : 1
5.SIGNAL CONTROL : ON
COMM. SETTING SELECTION
4.STOP BITS
5.SIGNAL CONTROL
6.XON/XOFF
7.PROTOCOL
8.RECORD DELIMETER
9.TRANS.COORD.AXIS
96
1.ON
2.OFF
ACCEP
T
1.ON
2.OFF