Electrical Requirements; Grounding Instructions - Alliance Laundry Systems JT30XG Manual De Instalación, Operación, Mantenimiento Y Seguridad

ELECTRICAL REQUIREMENTS

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be reconnected
to ensure that the tumbler is properly grounded.
To reduce the risk of fire and electric shock, check with a qualified serviceperson for
proper grounding procedures. Improper connection of the equipment grounding
conductor may result in a risk of electric shock.
To reduce the risk of fire and electric shock, if electrical supply is coming from a three
phase service, DO NOT connect a "High Leg" or "Stinger Leg" to a single phase machine.
On a three phase machine, if there is a "High Leg" or "Stinger Leg" it should be
connected to L3.

GROUNDING INSTRUCTIONS

This drying tumbler must be grounded. In the event of
malfunction or breakdown, grounding will reduce the
risk of electric shock by providing a path of least
resistance for electric current. This tumbler must be
connected to a grounded metal, permanent wiring
system; or an equipment grounding conductor must be
run with the circuit conductors and connected to the
appropriate ground location.
WARNING
All electrical connections should be
made by a qualified electrician.
To reduce the risk of electrical shock, de-
energize the electrical circuit being
connected to the tumbler before making
any electrical connections. Never attempt
to connect a live circuit.
42
W070
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
WARNING
WARNING
NOTE: To ensure protection against shock, this
tumbler MUST be electrically grounded in
accordance with the local codes, or in the absence of
local codes, with the latest edition of the National
Electrical Code ANSI/NFPA No. 70. In Canada the
electrical connections are to be made in accordance
with CSA C22.1 latest edition Canadian Electrical
Code, Part I and/or local codes. Electrical work
should be done by a qualified electrician.
Label all wires prior to disconnection
when servicing controls. Wiring errors
can cause improper and dangerous
operation. Verify proper operation after
servicing.
CAUTION
W002
W068R1
W069
W071
M414670