Alliance Laundry Systems JT30XG Manual De Instalación, Operación, Mantenimiento Y Seguridad página 74

B. Time Dry and No Heat
After fabric selection, press the TIME pad, see
Figure 39.
Figure 39
TIME DRY Pads
A preset drying time, "Td:**" will replace
"A0:00" in the display. This time can be changed
by pressing the MORE or LESS pads. For 1
minute changes, press pad and release. For 5
minute changes, press pad and hold. Maximum
drying time allowed is 60 minutes.
Cycles Preset Time
COTTONS
PERM PRESS
MIXED
DELICATES
NO HEAT
Table 17
AC:** will be displayed when tumbler is in Auto
Cool Down. Typical cool down times for fabric
selections are preset as shown in Table 16. The
cool down time can only be altered before cycle is
started. To alter cool down time press the COOL
DOWN pad and then press the MORE or LESS
pad (when cool down time is altered, TC:** will
be displayed). For 1 minute changes, press pad
and release. For 5 minute changes, press pad and
hold. Cooling time can be from 1 to 39 minutes.
To return to the Auto Cool Down, press MORE or
LESS pad until AC:** is displayed.
72
Range
35 Min 1-60 Min.
20 Min 1-60 Min.
15 Min 1-60 Min.
30 Min 1-60 Min.
20 Min. 1-60 Min.
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
To start the cycle, press START. The total drying
time plus cool down time will display. During the
cycle, remaining time displays.
NO HEAT is a time dry cycle only. When NO
HEAT is pressed, a 20 minute preset time will
display. This can be changed from 1 minute to 60
minutes by pressing the MORE or LESS pads
before pressing START. The COOL DOWN pad
does not work in NO HEAT cycles.
C. Special Cycle Mode
This allows the user to select the number of times
the tumbler will cycle from heat-on to heat-off. To
enter the Special Cycle Mode, press the
SPECIAL CYCLE pad after selecting a cycle.
The display will read "SC:**". "**" is the number
of times the tumbler will cycle from heat-on to
heat-off. This number can be changed by pressing
the MORE or LESS pads. For increments of 1,
press pad and release. For increments of 5, press
pad and hold for 3 seconds. Range is from 1-99.
Press the START pad and the number shown after
"SC:" is the number of cycles selected, the
number will decrease as each cycle is completed.
The default cool-down cycle for the Special Cycle
Mode is Automatic Cool Down.
NOTE: Since there is only 60 minutes of cycle time,
any cycles not completed within 60 minutes will be
skipped.
NOTE: Unlike the Time Dry mode and Automatic
mode, the regulating temperature in the Special Cycle
Mode has a range of 80°F to 180°F for all heat cycles.
M414670