Hach LANGE Manual Del Usuario página 11

Table 4 Block 3 Analyzer ERROR
Bit Error Note
0 Measurement Calibration An error occurred during the last calibration.
Error
1 Electronic Adjustment An error occurred during the last electronic
Error calibration.
2 Cleaning Error The last cleaning cycle failed.
3 Measuring Module Error A failure has been detected in the Measuring
Module.
4 System Re-initialization Some settings have been detected as
Error inconsistent and have been set to the factory
defaults.
5 Hardware Error Any hardware error has been detected.
6 Internal Communication A communication failure within the device has
Error been detected.
7 Humidity Error Excessive humidity has been detected in this
device.
8 Temperature Error The temperature within the device is more
than the specified limit.
9 — Fixed at zero.
10 Sample Warning Some action is necessary within the sample
system.
11 Questionable Calibration The last calibration may not be accurate.
Warning
12 Questionable One or more of the measurements of the
Measurement Warning device may not be accurate (Quality bad or
out of range).
13 Safety Warning A condition has been detected that may result
in a safety hazard.
Table 4 Block 3 Analyzer ERROR (continued)
Bit Error Note
14 Reagent Warning Some action is necessary with the reagent
system.
15 Maintenance Required Maintenance is necessary on this device.
Warning
Table 5 Block 3 Analyzer STATUS 1
Bit Status1 Note
0 Calibration in progress The device has been put in a calibration
mode. The measurements may not be valid.
1 Cleaning in progress The device has been put in a cleaning mode.
The measurements may not be valid.
2 Service/Maintenance menu The device has been put in a service or
maintenance mode. The measurements may
not be valid.
3 Common Error The device recognizes an error. See the error
registers for the error class.
4 Measurement 0 Quality Bad The precision of the measurement is out of
the specified limits.
5 Measurement 0 Low Limit The measurement is less than the
measurement range.
6 Measurement 0 High Limit The measurement is more than the
measurement range.
7 Measurement 1 Quality Bad The precision of the measurement is out of
the specified limits.
8 Measurement 1 Low Limit The measurement is less than the
measurement range.
9 Measurement 1 High Limit The measurement is more than the
measurement range.
10 Measurement 2 Quality Bad The precision of the measurement is out of
the specified limits.
English 11