Alpine CDE-175BT Manual De Operación página 12

6
Select [CDE-175BT] [CDE-172BT] [UTE-
73BT] (your model name) shown in the
display of the BLUETOOTH device.
If your model name does not appear, repeat
from step 2.
7
If passkey* input is required on the
BLUETOOTH device, input [0000].
* Passkey may be called "Passcode, " "PIN code, " "PIN
number" or "Password, " etc., depending on the
device.
Input passkey
[0000]
When pairing is made,
8
Select this unit on the BLUETOOTH
device to establish the BLUETOOTH
connection.
or lights up when the connection is
made.
Note
While connecting to a BLUETOOTH device, this unit
cannot be detected from another device. To enable
detection, enter the pairing mode and search for this unit
from another device.
To start playback
For details, see "Playing a BLUETOOTH Device
(CDE-175BT/ CDE-172BT/ UTE-73BT only)"
(page 17).
To disconnect the paired device
Perform steps 2 to 4 to disconnect after this unit
and the BLUETOOTH device are paired.
12
-EN
stays lit.
Connecting with a paired BLUETOOTH
device
To use a paired device, connection with this unit
is required. Some paired devices will connect
automatically.
1
Press and hold
seconds, rotate the control dial to select
[BLUETOOTH], then press it.
2
Rotate the control dial to select [BT IN],
then press it.
Make sure that lights up.
3
Activate the BLUETOOTH function on the
BLUETOOTH device.
4
Operate the BLUETOOTH device to
connect to this unit.
or lights up.
Icons in the display:
Lights up when handsfree calling is
available by enabling the HFP
(Handsfree Profile).
Lights up when the audio device is
playable by enabling the A2DP
(Advanced Audio Distribution Profile).
To connect the last-connected device from
this unit
Activate the BLUETOOTH function on the
BLUETOOTH device.
To connect with the audio device, press
SOURCE to select [BT AUDIO].
To connect with the cellular phone, press
Note
While streaming BLUETOOTH audio, you cannot connect
from this unit to the cellular phone. Connect from the
cellular phone to this unit instead.
Tip
With BLUETOOTH signal on: when the ignition is turned
to on, this unit reconnects automatically to the last-
connected cellular phone.
/SETUP for at least 2
.