Loading The Default Parameters - V2 ZARISS Serie Manual Del Usuario

9 - LOADING THE DEFAULT PARAMETERS

If necessary, it is possible to restore all parameters to their
standard or default values (see the final summary table).
m
PLEASE NOTE: This procedure results in the loss of
all customised parameters, and hence it has been included
outside the
configuration menu, in order to minimise the likelihood of
it being run in error.
Loading of the default parameters is performed each time
the initialisation procedure is performed (even without
working time self-training).
The parameters acquired during initialisation are
maintained, even when the default parameters are loaded.
-dEF
ESC
dEF.
1. Press and hold the OK key until the display shows
2. Release the OK key: the display shows
key if it is desired to exit this menu)
i
3. Press the key: the display shows
4. Press the OK key: the display shows
i
5. Press the key: the display shows
6. Press the OK key: all parameters are overwritten with their
default values, the control units exits programming mode and
the display shows the control panel.
no
Si
- 55 -
-dEF
ESC
(only press the OK
dEF
.
no
Si