Chain Lubricant; How To Start - Use - Stop The Engine - ST. SpA A 3700 Manual De Instrucciones

8
EN
REFUELLING
DANGER!
ling and avoid inhaling the petrol fumes.
WARNING!
top as pressure could have formed inside.
Before refuelling:
– Shake the fuel mixture container well.
– Place the machine on a flat stable surface, with
the fuel tank cap facing upwards.
– Clean the fuel tank cap and the surrounding
area to avoid any dirt from entering the tank
during refilling.
– Carefully open the fuel tank cap to allow the
pressure inside to decrease gradually. Use a
funnel to refill and avoid filling the tank to the
brim.
WARNING!
cap firmly.
WARNING!
ces of fuel which may have dripped on the
machine or the ground and do not start the
engine until the petrol fumes have dissipat­
ed.
6. HOW TO START - USE – STOP THE ENGINE
STARTING THE ENGINE
WARNING!
ed in an area at least 3 metres from where
you refilled the fuel tank.
Before starting the engine:
– Place the machine firmly on the ground.
– Take off the bar cover.
– Make sure the bar is not touching the ground or
any other object.
• Cold starting
NOTE
means starting it after at least 5 minutes from
when it was switched off or after refuelling.
PREPARING TO WORK / HOW TO START - USE – STOP THE ENGINE
Never smoke whilst refuel­
Carefully open the tank
Always close the fuel tank
Immediately clean all tra­
The engine must be start­
A "cold" start of the engine

CHAIN LUBRICANT

IMPORTANT
chain saws or adhesive oil for chain saws. Do not
use oil containing impurities so as not to block the
oil filter and to prevent irreparable damage to the
oil pump.
IMPORTANT
ing the chain is biodegradable. Use of a mineral
oil or engine oil causes serious damage to the
environment.
It is essential that you use good quality oil to lubri-
cate the cutting parts effectively. Used or poor
quality oil does not guarantee good lubrication
and reduces the duration of the chain and bar.
It is always worth topping up the oil tank com-
pletely (using a funnel) every time you refuel.
Since the oil tank capacity is enough to guarantee
that the fuel runs out first, you will avoid the risk of
operating the machine without lubricant.
To start the engine (Fig. 8):
1. Check that the chain brake is engaged (with
the front hand guard pushed forward).
2. Set the switch (1) to «START».
3. Pull the knob (2) as far as possible to engage
the starter.
4. Press the primer device button (3) 3 or 4 times
to prime the carburettor.
5. Hold the machine firmly on the ground, with
your hand on the handgrip and your foot in the
rear handgrip, to avoid losing control during
starting (Fig. 9).
WARNING!
firmly, the force of the engine could cause
the user to lose his balance or direct the bar
towards him or an obstacle.
Only use special oil for
The special oil for lubricat­
If the machine is not held