Ic Statement (For Canada Only) - Hilti PS 50 Manual De Instrucciones

NOTE
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
en
1. This device may not cause harmful interference.
2. This device must accept any interference re-
ceived, including interference that may cause
undesired operation.
For users in the USA
Operation of this device is restricted to law enforcement,
fire and rescue officials, scientific research institutes,
commercial mining companies, construction companies
and private parties operating on behalf of these groups.
Operation by any other party is a violation of 47 U.S.C.
§ 301 and could subject the operator to serious legal
penalties.
Coordination requirements
1. UWB imaging systems require coordination through
the FCC before the equipment may be used. The
operator shall comply with any constraints on equip-
ment usage resulting from this coordination.
2. The users of UWB imaging devices shall supply
detailed operational areas to the FCC Office of En-
gineering and Technology who shall coordinate this
information with the Federal Government through
the National Telecommunications and Information
Administration.
The information provided by the UWB operator shall
include the name, address and other pertinent con-
tact information of the user, the desired geograph-
ical area of operation, and the FCC ID number and
other nomenclature of the UWB device.
This material shall be submitted to the following
address:
Frequency Coordination Branch, OET
Federal Communications Commission
445 12th Street, SW
Washington, D.C. 20554
ATTN: UWB Coordination

13 IC statement (for Canada only)

This device complies with the requirements defined
in RSS-220 in conjunction with RSS-Gen of IC.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
26
3. Users of authorized, coordinated UWB systems may
transfer them to other qualified users and to different
locations upon coordination of change of ownership
or location to the FCC and coordination with existing
authorized operations.
4. The NTIA/FCC coordination report shall include any
needed constraints that apply to day-to-day oper-
ations. Such constraints could specify prohibited
areas of operations or areas located near author-
ized radio stations for which additional coordination
is required before operation of the UWB equipment.
If additional local coordination is required, a local
coordination contact will be provided. Ground Pen-
etrating Radar Coordination Notice And Equipment
Registration.
NOTE
This form is only for domestic United States users. Failure
to do this is a violation of Federal law.
1. Date:
2. Company name:
3. Address:
4. Contact information [contact name and phone num-
ber]:
5. Area of operation [state(s)]:
6. Equipment identification
Designation: PS 50
FCC-ID: SDL-PS38R01
7. Receipt date of equipment:
Fax this form to the FCC at: 202-418-1944
or mail it to:
Frequency Coordination Branch, OET
Federal Communications Commission
445 12th Street, SW
Washington, D.C. 20554
ATTN: UWB Coordination
Do not send this information to Hilti Corporation.
2. This device must accept any interference re-
ceived, including interference that may cause
undesired operation.
For users in Canada
This device shall be operated only where directed to the
ground or wall, and where it is in contact with the ground
or wall surface. This device shall be operated only by
law enforcement agencies, scientific research institutes,
commercial mining companies, construction companies,
and emergency rescue or fire-fighting organizations.