Functional Description; Operation; Settings; Electronics - Festool ETS EC 150/3 EQ Manual De Instrucciones

Lijadora excentrica
Ocultar thumbs Ver también para ETS EC 150/3 EQ:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The pictures for the functional description are on a
fold-out page at the beginning of the instruction
manual. While reading the manual you can fold out
the page for comparison and quick reference.
[1-1]
ON/OFF button
[1-2]
Speed control
Consider the pictures on the fold-out page.
WARNING
Unauthorised voltage or frequency!
Risk of accident
The mains voltage and the frequency of the pow-
er source must correspond with the specifica-
tions on the machine's name plate.
In North America, only Festool machines with
the voltage specifications 120 V/60 Hz may be
used.
Connecting and detaching the mains power cable -
see Fig. [2].
Before switching on the machine make sure
that the bayonet fitting at the power supply
cord is closed fully and locked.
WARNING
Risk of injury, electric shock
Always pull the mains plug out of the socket be-
fore performing any type of work on the ma-
chine!

Electronics

The power tool is equipped with a brushless EC-
TEC motor for a long service life and power elec-
tronics with the following properties:
10

Functional description

[1-3]
[1-4]
[1-5]
[1-6]
[1-7]

Operation

ON/OFF button [1-1]
ON
OFF
 When the extractor signal is active, the power
tool cannot be switched on without a connected
extractor hose - see chapter Extractor signal.
 In case of a power failure or if the mains con-
nector is removed, move the on/off switch im-
mediately to the Off position. This prevents un-
controlled restarting.

Settings

Smooth start-up
The electronically controlled smooth start-up en-
sures that the machine starts up jolt-free.
Constant speed
The preselected motor speed is kept constant
through electronic control to ensure a uniform
sanding speed even when under load.
Speed reduction in the event of high vibrations
If high vibrations and oscillations occur at the pow-
er tool, e.g. with the use of an interface pad, the
speed is automatically reduced in order to protect
the power tool and the user.
Sanding pad
Plug it-connection
Extractor connector
LED for extractor signal
Handle (insulated gripping surface)
Press the ON/OFF button [1-1]
Press the ON/OFF button [1-1]
2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ets ec 150/5 eq

Tabla de contenido