Assembly Preparation; Assembly Instructions; Mounting The Wheels To The Legs; Assembling The Cart - Pit Boss PB820SC Instrucciones Y Recetas

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister
pack after removing from the protective shipping carton. Before assembly of product, review all parts and reference the parts
list. If any part is missing or damaged, do not attempt to assemble. Shipping damage is not covered under warranty. Contact your
dealer or Pit Boss Customer Service for parts: Monday through Sunday, 4am - 8pm PST (EN/FR/ES).
service@pitboss-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
Tools required for assembly: screwdriver and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closest to the head of the screw.

1. MOUNTING THE WHEELS TO THE LEGS

Parts Required:
Support Leg (#14)
4
x
Locking Caster Wheel (#22)
4
x
Installation:
Insert one of the pre-threaded locking caster wheels into the bottom
of a support leg by hand-tightening it into the hole. Continue to install
the other caster wheels to the remaining support legs.

2. ASSEMBLING THE CART

Parts Required:
1
x
Bottom Shelf (#21)
8
x
Screw (#A)
8
x
Locking Washer (#C)
8
x
Washer (#B)
Installation:
Attach the bottom shelf to one of the four support legs using two washers,
locking washers, and screws. Note illustration for support leg placement.
On a level surface, continue to secure the other support legs to the
bottom shelf.
IMPORTANT: The edge of the bottom shelf with holes should face
forward. The holes are for the cabinet doors installation.

3. MOUNTING THE CART PANELS

Parts Required:
2
x
Cart Side Panel (#24)
1
x
Cart Back Panel (#23)
Screw (#D)
12 x

ASSEMBLY PREPARATION

ASSEMBLY INSTRUCTIONS

1
2 2
14-2
14-1
14-3
A
C B
3
14-4
7

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

150011472825

Tabla de contenido