Electric Connection - Cadel CLOE Manual De Instalación

Fig. 31 - Panels assembly
• Insert the metal side panles from above, placing the two teeth on the special slots and pushing all the
way down (see Fig. 31 page 73).
• Use no.8 wrench to tightenthe two screws under the panel (see Fig. 32 page 73).
9.8

ELECTRIC CONNECTION

Warning: the appliance must be installed by an authorized technician!
• The electric connection occurs through a cable with plug put in an electric socket which is able to
support charge and tension specific of every model, as described in the technical datas table (see
FEATURES page 98).
• The plug must be easily accessible when the appliance is installed.
The cable must not get in touch with the fume exhaust pipe and nor with every other
part of the stove.
• Please further assure you that your network is endowed with an efficient earth connection: if it does not
exist or if it is not efficient, please endow you with one in compliance with the law.
• Connect the supply cable first on the back of the stove (see Fig. 33 page 73) and then at a wall
electric socket.
• The master switch O/I (see Fig. 33 page 73) is to open only to switch the stove on, otherwise it is
advisable to keep it off.
• Do not use extension cables.
CLOE - SQUARE
Fig. 33 - Electric socket with master switch
Fig. 32 - Panels fixing
EN
73