Publicidad
4
Construction
The jointing system VS 600 consists of the following
components (Figure 1):
1.1 Base frame
1.2 Mount for templates
1.3 Rotary knob to clamp the templates
1.4 Swivel segment for mount
1.5 Clamping lever for swivel segment
1.6 Clamping lever to adjust the height of the tem-
plates
1.7 Pressure beam for horizontal clamping of the work-
pieces
1.8 Pressure beam of vertical clamping of the work-
pieces
5
Preparation
5.1
Setting up the base frame
The base frame must be fastened to a non-slip fi rm
base:
• Set the base frame up so that the front edge protrudes
by approx. 5 mm.
• Fasten the base frame on both sides of the base with
two screws (Figure 2) or two screw clamps (Figure 3).
5.2
Pressure beams
Both pressure beams can be adjusted with a rotary knob
in the centre bore or a third rotary knob (accessory) can
be fi tted to clamp narrow workpieces (< 250 mm width)
evenly.
The tool already has an additional sliding block.
5.3
Router
Note: Handling of the router (adjusting the routing
depth, changing tools, etc.) is described in its operating
instructions.
Mount the required copying ring centrally in the
routing plate of the router:
• Unplug the tool from the mains.
• Turn the router upside down.
• Open the two screws (4.1) and remove the ring (4.2).
• Clamp the centring mandrel (4.4) tight in the cutter
spindle.
• Place the copying ring (4.5, 5.3) into the router's routing
plate with the collar uppermost.
• Slowly move the routing plate towards the centring
mandrel until the centring ring (5.3) is centred by the
centring mandrel (5.2).
• Screw the copying ring tight with the two enclosed
screws (4.3, 5.1).
• Remove the centring mandrel from the cutter spindle.
18
Publicidad
