Festool VS 600 Instrucciones De Servicio página 40

Ocultar thumbs Ver también para VS 600:
Tabla de contenido

Publicidad

• Unclamp the workpiece and place it together with a
workpiece with dovetails. If the joints do not fi t exactly
together, the following corrections should be made:
° The joints are too tight (33.1):
Turn the adjustment wheels towards plus.
° The joints are too loose (33.2):
Turn the adjustment wheels towards minus.
° The joints are too deep (33.3):
Slightly reduce the routing depth on the router using
the router's precision adjustment feature.
° The joints are not deep enough (33.4):
Slightly increase the routing depth on the router using
the router's precision adjustment feature.
Note: In order to adjust the adjusting wheels the
screws (34.1) have to be opened and retight-ened after
adjustment. This locks the pre-set position for later
working.
• Repeat this procedure until the joint fi ts exactly.
Routing the dovetails
Rout all dovetails analogous to the trial routing.
40

Publicidad

Tabla de contenido
loading

Tabla de contenido