Brother 9600 Guía De Usuario página 66

Ch. 3 Functions
Font function (FONT)
With the Font function, you can change the font
of the text to one of the many that are available.
For samples of the available Font settings, refer
to page 99. The font of the text at the cursor's
current position is shown at the bottom of the
display.
1 2 3 4 5 6 7 8 9 A
R
R
G
<<< P-touch >>>
R
N O
H
R
L M
R
I
1:_
R
J
AUTO 1.10
Length Margin
NOTE
Letter Gothic (L. GOTHIC) is a fixed pitch font (all
characters use a fixed amount of space), as opposed
to all of the other fonts, which are proportional
(characters use different amounts of space).
To change the setting for the Font function:
1 Hold down d and press 1, 2 or 3.
NOTE
This step may be skipped if settings for several for-
mat functions are being applied at the same time.
2 Press j or k until FONT is displayed.
The setting for the text at the cursor's cur-
rent position is shown on the left side of the
display and a sample can be seen on the
right side.
1 2 3 4 5 6 7 8 9
R
R
G
01/13
R
H NO
R FONT
L
R
I
M
HELSINKI
R
J
AUTO 1.10
Length Margin
3 Press m or g until the desired setting is
displayed.
54
K Q Q Q Q Q
B C D E F
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q
HELSINKI A AUTO
Font Width Size
K Q Q Q Q Q
A B C D E F
Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
HELSINKI A AUTO
Font Width Size
NOTE
☞
If "*****" appears as a setting, the Font function
has already been applied to part of the current
text (either a line in the current block if the
Block Format or the Global Format function is
being set or a block in the text if the Global For-
mat function is being set). Changing the setting
will cancel the setting that was previously
applied.
☞
To return the function to its default setting (HEL-
SINKI), press the space bar.
☞
To return to the text without changing the for-
e
matting, press
1 2 3
press , or
4 Press n to apply the setting.
NOTE
To apply several format settings at the same time,
continue pressing j or k to select the function,
then pressing m or g to select the desired setting.
Press n only after the necessary functions have
been set.
Size function (SIZE)
The character size can be adjusted using the
Size function. With the AUTO setting, the
machine compares your text with the width of
the installed tape and automatically adjusts the
characters to the largest possible size. For sam-
ples of the available Size settings, refer to
page 100. The size of the text at the cursor's cur-
rent position is shown in the lower-right corner
of the display and with the indicator on the right
side of the display.
1 2 3 4 5 6 7 8 9
R
R
G
<<< P-touch >>>
R
N O
H
R
L M
R
I
1:_
R
J
AUTO 1.10
Length Margin
d
(OR hold down and
).
K Q Q Q Q Q
A B C D E F
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q
HELSINKI A AUTO
Font Width Size