Brother 9600 Guía De Usuario página 71

To change the setting for the Line Effects
function:
1 Hold down d and press 1, 2 or 3.
NOTE
This step may be skipped if settings for several for-
mat functions are being applied at the same time.
2 Press j or k until LINE EFFECTS is dis-
played. The setting for the text at the cur-
sor's current position is shown on the left
side of the display and a sample can be
seen on the right side.
1 2 3 4 5 6 7 8 9
R
R
G
06/13
R
H NO
R LINE EFFECTS
L
R
I
M
OFF
R
J
AUTO 1.10
Length Margin
3 Press m or g until the desired setting is
displayed.
NOTE
☞
If "*****" appears as a setting, the Line Effects
function has already been applied to either a
line in the current text block (if the Block For-
mat or the Global Format function is being set)
or a block in the current text (if the Global For-
mat function is being set). Changing the setting
will cancel the setting that was previously
applied.
☞
To return the function to its default setting
(OFF), press the space bar.
☞
To return to the text without changing the for-
e
matting, press
1 2 3
press , or ).
4 Press n to apply the setting.
NOTE
To apply several format settings at the same time,
continue pressing j or k to select the function,
then pressing m or g to select the desired setting.
Press n only after the necessary functions have
been set.
K Q Q Q Q Q
A B C D E F
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q
HELSINKI A AUTO
Font Width Size
d
(OR hold down and
Frame function (FRAME)
With the Frame function, you can choose from a
variety of frames and highlights for emphasizing
certain parts or all of the text in your label. For
samples of the available frame settings, refer to
page 104. When any setting other than OFF is
selected for the text at the cursor's current posi-
tion, the Frame indicator at the top of the dis-
play comes on. The lines on the right side of the
indicator, starting from the top, show if the
Frame setting is applied to the entire text, the
block or the line.
1 2 3 4 5 6 7 8 9
R
R
G
<<< P-touch >>>
R
N O
H
R
L M
R
I
1:_
R
J
AUTO 1.10
Length Margin
To change the setting for the Frame function:
1 Hold down d and press 1, 2 or 3.
NOTE
This step may be skipped if settings for several for-
mat functions are being applied at the same time.
2 Press j or k until FRAME is displayed.
The setting for the text at the cursor's cur-
rent position is shown on the left side of the
display and a sample can be seen on the
right side.
1 2 3 4 5 6 7 8 9
R
R
G
07/13
R
H NO
R
FRAME
L
R
I
M
OFF
R
J
AUTO 1.10
Length Margin
3 Press m or g until the desired setting is
displayed.
Ch. 3 Functions
K Q Q Q Q Q
A B C D E F
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q
HELSINKI A AUTO
Font Width Size
K Q Q Q Q Q
A B C D E F
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q
HELSINKI A AUTO
Font Width Size
59