Legal Information - Ottobock 10V39 Instrucciones De Uso

Apply the 636K14 Loctite® 601 on the lower third of the thread surface
of the terminal device (fig. 12). Screw the terminal device completely into
the 10A30=* Adapter. Remove excessive Loctite®. Mount the terminal
device with adapter into the wrist unit and align the terminal device to the
lower arm, if necessary, by unscrewing from the adapter (by a maximum
of ¼ turn) (fig. 13). Remove the terminal device with the 10A30=* Adapter
from the wrist unit again and remove excessive Loctite® from the terminal
device or wrist unit. Let the adhesive air dry according to the manufac-
turer's specifications.
Mounting the adapter 10A30=1
Adapter for using the 10V39 in conjunction with terminal devices with
standard pins.
Insert the standard pin of the terminal device into the standard connection
of the 10A30=1 and secure the closure by turning the clamp sleeve to the
right. Mount the terminal device with adapter into the wrist unit.
7.3 Fabricating a laminated socket
Use the 743A18 Alignment Tool with wrist unit diameter 45 mm or 50 mm
during the fabrication of the laminated socket. For assembly of the 10V39
MovoWrist Flex, please follow the instructions under section 7.1.

8 Legal information

All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
8.2 Liability
The manufacturer will only assume liability if the product is used in accor-
dance with the descriptions and instructions provided in this document.
The manufacturer will not assume liability for damage caused by disregard
of this document, particularly due to improper use or unauthorised modi-
fication of the product.
8.3 CE conformity
This product meets the requirements of the European Directive 93 / 42 / EEC
for medical devices. This product has been classified as a class I device
according to the classification criteria outlined in Annex IX of the directive.
The declaration of conformity was therefore created by the manufacturer
with sole responsibility according to Annex VII of the directive.
16 | Ottobock