Relocating The Wheel - Stihl FW 20 Manual De Instrucciones

1
1
Slacken the two nuts (1) on the
N
underside of the cart
If the direction deviates to the left
Swing the support (2) a few
N
millimeters to the left and retighten
the two nuts
If the direction deviates to the right
Swing the support (2) a few
N
millimeters to the right and retighten
the two nuts
Check the direction again and
N
repeat the adjustment until it is
correct.
A minor adjustment is usually all that is
needed to correct any deviation in
direction.
FW 20

Relocating the wheel

Cutting close to kerb stones
1
When cutting close to kerb stones, the
right-hand wheel can be relocated from
outboard to inboard position, thus
making it unnecessary to change the
abrasive wheel to the "outboard"
position.
Remove the screw (1) and take the
N
wheel with axle out of the bearing in
the frame, then refit it on the inboard
side and secure it with the screw.
Cutting kerb stones
For cutting kerb stones, the front wheel
can be mounted in a position further to
the rear.
2 1
3
Unscrew nut (1) and remove with
N
washer (2)
Remove wheel (3)
N
2 1
3
Insert axle of wheel (3) in the rear
N
hole
Slide on washer (2), screw on and
N
tighten nut (1)
English
15