Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English / USA
Mounting the KombiTool
2
1
4
3
Mounting
:
Engage lug (1) on drive tube in
slot (2) in the coupling sleeve and
push home the drive tube as far as
stop.
:
When correctly installed, the red
line (3) (arrow point) must be flush
with the end of the coupling sleeve.
:
Tighten the wing screw (4) firmly.
Removing
:
Reverse the above sequence to
remove the drive tube.
16
Mounting the Deflector
2
3
Fitting the Line Limiting Blade
:
Slide the blade Messer (1) into the
guide on the deflector.
:
Use the combination wrench (3) –
supplied with the KombiEngine or
available as special accessory – to
insert the screw (2) and tighten it
down firmly.
2
1
1
Mounting the Deflector
:
Slip the clamp (1) over the lug (2) on
the deflector and hold it in position.
:
Ease the other side of the clamp (1)
over the deflector.
FSB-KM
Publicidad
Capítulos
Tabla de contenido
