Baby Unit Power Supply; Parent Unit Battery Installation; Parent Unit Power Supply - Topcom 2100 Manual De Usuario

5.2

Baby unit power supply

1. Connect the small plug of the AC adaptor to the power connector of the baby unit and
the other end of the adapter cable to the electric socket (230V/50Hz).
Only use the enclosed adapter (6V DC / 500mA).
2. Press the On/Off button (14). The power (16) LED will illuminate.
3. Press and hold the On/Off button (14) to switch off the baby unit.
5.3

Parent unit battery Installation

1. Turn the belt clip facing upwards.
2. Turn the screw 90° of the battery cover (11) on the backside
of the parent unit in a counter clockwise direction using a
screw driver. Remove the battery cover (12). Do not try to
rotate the screw further than the position 'open'.
3. Place the NiMH battery pack in the battery compartment.
Ensure that the connector of the battery pack (A) is
connected and that the polarity matches the figure (B). The
red wire = positive (+) polarity.
Do not install alkaline batteries!
4. Close the battery compartment.
5. Press the On/Off button (2). The power LED (7) will
illuminate.
6. Press and hold the On/Off button (2) to switch off the parent
unit.
5.4

Parent unit power supply

1. Connect the power adapter cable to the main
power socket (230V/50Hz).
Only use the enclosed adapter
(7V DC / 420mA).
2. Slide the Parent Unit into the charger. The red
charging light (6) illuminates.
3. It takes about 13 hours to charge the unit.
4. Press the On/Off button (2). The power LED (7)
will illuminate.
5. Press and hold the On/Off button (2) to switch off the patent unit.
All manuals and user guides at all-guides.com
Topcom Babytalker 2100
B
A
-
+
7