Control Board Standard Programming - Dea GEKO Instrucciones De Uso

5.2 Control board standard programming

1
Power Supply
Give power supply, the display shows the following symbols "
2
Messages concerning working status
1. Press on the key;
2. Check that the display shows the correct outputs status.
3
1 or 2 operators operating selection
1. Scroll down the parameters until you visualize P020;
2. Confirm by pressing on the
3. By pressing on and , keys, set up:
- d001=for 1 operator mode;
- d002=for 2 operators mode;
4. Confirm by pressing on the
P020).
4
Learning of operators stroke
4.1 Positioning leaf 1
1. Scroll down the parameters until you visualize P001;
2. Confirm by pressing on the
3. By pressing (open) and
happen, you must swap the two motor 1 cables), position
leaf n.1 in its standstill position while opening;
4. Confirm by pressin on the
4.2 Positioning leaf 2 (only for 2 operators)
1. Scroll down the parameters until you visualize P002;
2. Confirm by pressing on the
3. By pressing (open) and
you must swap the two motor 2 cables), position leaf n.2 in
its standstill position while opening;
4. Confirm by pressing on on the
P002).
key;
key (display shows again
key;
(close) keys (if this does not
key (display shows again P001).
key;
keys (if this does not happen,
key (display shows again
", " ", " " and then "----"
EN
15
G E K O