Festool DWC 18-2500 Manual De Instrucciones página 18

GB
D U R A D R I V E
Read the set screw length on the depth stop sides
.
Pull the collated screws
tom guiding of the attachment, then push the
strip through the second guiding until it engag-
es in the working position.
Pull the belt slightly to make sure that it is safe-
ly fitted.
Make sure that the first screw is in the screwing
axes – see figure
Use the wheel
ing depth.
Turn to the right for inserting the screws deeper,
and to the left to screw to lower depth. The ac-
tual setting position is visible on the presetting
indicator .
Upon setting, set some screws for testing and use
the wheel to adjust the depth, if required.
Each setting change complies with the stop shift o
± 0.1 mm.
We recommend to screw in automatic mode –
see point 9.1 b).
Pull upwards to remove the belt (figure
or press the transport lever and concurrently
pull the belt downwards (figure
– The magazine attachment must not be held in the
depth stop area as there are moving parts!
– Each screw adjustment must be completed. In-
terrupted fastening or releasing of the pressure
during adjustment can result in unsatisfactory
machine function.
– The collated screws and the magazine attach-
ment can only be replaced when the power tool is
turned off.
– Never use the magazine attachment in any other
way than specified in this instruction manual.
– Use only original screwing bits.
– Use only original collated screws.
– Always store the collated screws in original
packaging.
– Always work in right angle against the attached
board.
The attachment generally does not require any
maintenance. After long period use, we recom-
mend to clean with pressurized air.
18
through the bot-
.
to set the required screw-
).
The magazine attachment may be lubricated in the
area of the carriage guide (see picture
Prior to cleaning, dismantle the attachment, as
specified above.
Prior to cleaning, remove the collated screws from
the attachment, as specified in the chapter 9.4 point
<Removing the collated screws>.
Pull the magazine attachment from the drywall
screwdriver.
Push the depth stopper
until the arresting button
the sign for dismantling the slides
figure .
Press the arresting button
rently remove the slides from the holder – see
figure .
Press the button
the depth stopper – see figure
Press the button
out – see figure
Remove the released button
) with the transport lever
) spring from the slides (figure
Clean individual parts, replace defective or worn
parts, and assemble in the opposite sequence.
During reassembly of the transport lever into
the slides, pay due care to correct fitting of
the spring
correct assembly may result in dysfunction
of the belt transport.
Acoustic warning signals sound and the machine
switches off in the following operating states:
– Change the battery.
– Place the machine under reduced
stress.
– You must allow the machine to
cool before using again.
– Once the battery pack has cooled,
perform a functional check using
the charger.
).
into the housing
is at the level of
– see
and concur-
and concurrently release
.
and concurrently pull it
.
(figure
and the
).
in the transport lever. In-