Omnitronic CDP-2400 Manual Del Usuario página 28

18. PITCHFADER
You can adjust the desired speed with the Pitchfader. The display shows the current percentage.
19. DISPLAY
VFD-display for displaying the different modes and functions. Please refer to the explanations under 6.3
VFD-display.
20. LOOP IN/REALTIME CUE-BUTTON
By pressing the In-button, you can memorize the Cue-point. Furthermore, you can program the In-button of a
sequence which will be repeated then.
Please refer to the explanations under 6.9 Memorizing a sequence (Loop-function)and 6.8 Interactive
scratch-wheel.
21. LOOP OUT-BUTTON
By pressing the Out-button, you can memorize the Loop Out-button. The player will repeat the memorized
sequence until you press the Out-button once more.
22. RELOOP-BUTTON
Via the RELOOP-button, you can call up a memorized sequence once more.
23. CUE-BUTTON
Pause-mode:
In the pause-mode, you can cue by pressing and holding the Cue-button. As soon as you let the Cue-button
loose, the player returns to the track-start or the Cue-point.
Playback-mode:
If you press the Cue-button during playback, the player returns to the track-start or the Cue-point and goes
into Pause-mode.
On the Cue-button, you can memorize the fourth Cue-point.
Please refer to the explanations under 6.7 Cueing.
24. PLAY/PAUSE-BUTTON
With the Play/Pause-button, you can start the playback and stop it again. Please refer to the explanations
under 6.4 Play/Pause.
25. SINGLE-BUTTON
For choosing single playback or continous play. By pressing this button once, the display shows „SINGLE".
The current track is then played once and the player goes into Pause-mode at the next track-start.
26. TIME-BUTTON
The display can be switched from track remain time (Remain) to total remain time (total remain) or track
playback time (Elapsed).
27. MEMORY/RECALL-BUTTON
With this button, you can memorize the current Cue-point, the current sample or the sample-parameter via
one of the three Bank/Cue-buttons. Press the Memory/Recall-button (LED on) and the desired Bank/Cue-
button. Please refer to the explanations under 6.7 Cueing and 6.10 Sampler-mode.
You can memorize up to 3 Cue-points and samples with sample-parameters of different titels and recall
them via the respective Bank/Cue-button.
Please note that the maximum sample-length is 7 seconds.
In the Effect-mode, you can memorize the adjusted effect parameters by adjusting the parameter and
pressing the Memory/Recall-button.
You can recall all memorized Cue-points, samples and effect-parameters from up to 500 CDs by switching
the CD-player on, pressing the Memory/Recall-button (LED on) and inserting the respective CD.
28. SAMPLER-BUTTON
By pressing the Sampler-button (Sampler LED on), you can recall a sample you memorized on one of the
Bank/Cue-buttons before.
The memorized samples of a CD remain in the memory until you switch off the CD-player or overrite the
samples.
You can recall all memorized Cue-points, samples and effect-parameters from up to 500 CDs by switching
the CD-player on, pressing the Memory/Recall-button (LED on) and inserting the respective CD.
Please refer to the explanations under 6.10 Sampler-mode.
28/71 10602365X17NXS_V_1_0.DOC