Installation; Operation; Setup; Cd-Tray - Omnitronic CDP-2400 Manual Del Usuario

35. CONNECTOR PORTS
Connect the main unit here.
36. CONTROL-SOCKETS
Via the Control-socket, the respective CD-player can be remotely controlled. If you are using a mixer with
Faderstart-function connect the player with the Control Out-socket. Please note that these sockets must
never be connected with any voltage. Please refer to 6.13 Faderstart.

5. INSTALLATION

Install the CD-player on a plane surface or in your rack.
Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
Rack-installation: This CD-player is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the CD-player into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the CD-player with four screws M6 in the rack.
Be aware that fastening the device with four screws on the front panel is not enough. In order to ensure
safety, additional fastening by using ground and side bars is necessary.
CAUTION: Make sure that the CD-player is switched off (power-switch in outer position) before you connect
it to the mains in order to avoid damages on your loudspeakers.
Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the
right/left occupation (plug-colour red/white) is the same at both devices.
Make sure that the indication on the Voltage-selector corresponds to the available voltage in order to avoid
severe damages. Only plug the power-plug into safety-sockets.
Connect your CD-player with the mains.

6. OPERATION

6.1 Setup

Switch the CD-player on via the Power-switch.
When the device is on and the tray has no disc, "NO DISC" appears on the display.

6.2 CD-tray

Press Open/Close-button in order to open the disc tray. The CD-tray opens, the status-LED flashes and the
display shows "OPEN".
Insert your CD in the CD-tray. Make sure that you only hold the CD with 2 fingers on the edge. Avoid
touching the inside area of the CD.
CAUTION: Do not close the tray by pushing it as this could harm the construction.
Press the Open/Close-button again in order to close the tray. The status-LED flashes until the tray is closed.
The LED is turned off and the player is ready for operation.
30/71 10602365X17NXS_V_1_0.DOC