Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6.3 VFD-display
If the CD is improperly positioned,"ERR" or "NO DISC" appears on the display.
If the CD is properly positioned, the total number of tracks and the total playback time are shortly displayed.
6.4 Play/Pause
In the Pause-mode the the time-indication in the display stands still and the Play/Pause-LED flashes. The
playback of the first track can be started by pressing the Play/Pause button. In the Playback-mode, the time-
indication in the display is running and the Play/Pause-LED shines permanently.
If you wish to interrupt the playback, press the Play/Pause-button and the laser stops at the position where
you stopped.
6.5. Selecting a track via the Track-buttons
You can select the desired track via the Track-buttons.
In order to play a track from the beginning, press the Track-buttons until the desired track number is
displayed. If you hold the respective Track-button, the CD-player will run through the track numbers until you
let the button loose.
«-button:
If you press the «-button once, playback starts at the beginning of the previous track. If a track is already
played back, you can start the current track from the beginning.
»-button:
If you press the »-button once, the playback starts at the beginning of the next track, if you press it twice the
following track, etc.
Please note that the CD-player calls the track up in the mode you pressed the Track-button. If the CD-player
is in the Play-mode at track 1 for example and you press the »-button, the player jumps to track 2 and
immediately starts playback.
+10-button:
By pressing the +10-button, the CD-player jumps 10-stepwise from track number to track number (e. g. 06,
16, 26, 06).
6.6 Adjusting the playback-speed
Possibility 1:
Via the Pitchfader, you can adjust the playback-speed by up to +/-100 %.
Put the CD-player into playback-mode. Press the Pitch Control-button in order to activate the Pitchfader
(LED on).
Select the speed-adjustment range by pressing the 4/8/16/100%-button: +/- 4 % (LED red), +/- 8 % (LED
flashes red) +/- 16 % (LED blue) or +/- 100 % (LED flashes blue).
The player jumps to the first track and is in the
Pause-mode (Play/Pause-LED flashes). Please note
that the player automatically jumps to the section
where the music starts.
Below "TRACK" the track number is displayed. The
track remain time is displayed in M (MIN), S (SEC)
and F (FRAME).
By using the Time-button, the time-indication can be
switched from track remain time (Remain) to total
remain time (Total Remain) to track playback time
(Elapsed).
Below the time-indication, 10 bars are displayed
showing the remaining track-time visually. The
shorter the track remain time becomes, the less bars
are displayed. 15 seconds before the track-end, the
bars in the display start flashing.
By pressing the Single-button, the CD-player is put
into Single-mode and the display shows "SINGLE".
The indication "0.0" means that the playback-speed
has not been changed. If you adjust the playback-
speed via the Pitchfader (Pitch-LED is flashing), the
respective percentage is indicated in the display.
31/71
10602365X17NXS_V_1_0.DOC
Publicidad
Tabla de contenido
