Selecting The Measurement Parameter - Thermo Scientific Orion Star Manual Del Usario

Selecting the Measurement Parameter

In the measurement mode, the arrow icon on the left side of the display indicates
the active line . Press
and press /
the selected line .
The measurement lines and icons for the 5-Star multi-parameter meter are shown
below . The single and dual parameter meters will have fewer measurement lines
and icons, depending on the meter capabilities .
pH
mV
RmV
ISE
No icon for temperature
No icon and no measurement – the measurement line is turned off
μS/cm or mS/cm for conductivity
mg/L for TDS
ppt for salinity
MΩ-cm for resistivity
No icon for temperature
No icon and no measurement – the measurement line is turned off
% sat for dissolved oxygen percent saturation
mg/L for dissolved oxygen concentration
No icon for barometric pressure
No icon for sample temperature
No icon for membrane temperature (polarographic DO readings only)
No icon and no measurement – the measurement line is turned off
Note: If a measurement line is not needed, press
icon to the measurement line that is not needed and press
measurement line is completely blank.
Thermo Scientific Orion Star
to move the arrow icon to the desired measurement line
to scroll through the measurement parameters associated with
and Star Plus Meter User Guide
™
to move the arrow
/ until the
Meter Setup
EN-17