Safety; Explanation Of Warning Symbols; Safety Instructions For Assembly; Delivery - Ottobock 491S75-ST150 Instrucciones De Uso

4 Safety

4.1 Explanation of warning symbols

Warning regarding possible serious risks of accident or injury.
WARNING
Warning regarding possible risks of accident or injury.
CAUTION
Warning regarding possible technical damage.
NOTICE

4.2 Safety Instructions for Assembly

WARNING
Uncontrolled movement of components when making adjustments
Crushing, pinching, blows due to non-observance of the maintenance and repair instructions
► Ensure that body parts, such as hands or head, are never in the danger zone.
► Perform the work with the aid of a helper for support.
CAUTION
Improper lifting
Crushing, pinching, blows due to failure to observe safety instructions
► Some parts of the power wheelchair, such as the batteries, frame, seat, and motors, are very heavy. Ensure
ergonomically correct lifting of these parts. Use sufficiently large hoisting devices or perform this work with a
helper.
► If it is necessary to work underneath raised parts or equipment, make sure these are secured by suitable
means so that they cannot come loose, shift, or fall down.
► When using lifting platforms, ensure that the power wheelchair is centred on the platform and that no parts
protrude into the danger zone.
NOTICE
Improper preparation before making adjustments
Damage to the product due to falling down and failure to follow setting instructions
► When you work on the product, secure it so that it cannot tip over or fall down.
► Turn the power wheelchair off and deactivate the circuit breaker before making any adjustments. Functional
tests of the electrical components are excepted from this rule.
► Before performing any work on the seat, ensure that the cushion is sufficiently protected against mechanical,
chemical, and thermal effects.

5 Delivery

5.1 Scope of delivery

The Ottobock scope of delivery includes:
Ottobock installation kit for the "Dahl docking system" (see fig. 1)
Order number
Item Article designation
1 Protective pads (for VAS seat)
2 Hook-and-loop strips, self-adhesive (for VAS seat)
3 Edge protection (for standard seat)
The following parts are required from Dahl:
Adaption set supplied by Dahl for 490E75=0_C/Ottobock* (see fig. 2, left)
Order number
Item Article designation
1 M8 hexagon nut
491S75=ST150, 491S75=ST155
490E75=0_C: 491S75=ST150 (standard seat); 491S75=ST155 (VAS seat)
503261*
Safety
Quantity
2
2
2
Quantity
5
15