Use; Prescribed Use Of Head Supports; Use In Vehicles For Transporting Persons With Reduced Mobility - Ottobock 491S75-ST150 Instrucciones De Uso

Use

Installation of the attachments supplied by Ottobock on the standard seat (edge protection)
1) Cut the edge protection to size if required. The length is dependent on the length of the edge of the end plate
(see fig. 11, arrow).
2) Position the edge protection on the edge of the end plate and press it on by hand (see fig. 12).
3) Attach the second edge protection on the other side in the same way.
7 Use

7.1 Prescribed use of head supports

WARNING
Non-observance of the Ottobock user guide
Serious injuries in case of accidents due to user error
► When using the Dahl docking system with approved Ottobock power wheelchairs, the installation of an
Ottobock head support approved for use in combination with the Dahl docking system is mandatory.
► Note the list of possible head supports below.
The following head supports are approved for use in connection with the Dahl docking system:
Code number
EL006
EL007
EL009
EL011
EL012
EL013
EL014
EL015
EL016
EL017
EL020

7.2 Use in vehicles for transporting persons with reduced mobility

WARNING
Non-observance of the Dahl user guide
Serious injuries in case of accidents due to user error
► Before using the Dahl docking system in vehicles for transporting persons with reduced mobility, read the
installation and operating instructions and in particular the safety notices of the manufacturer.
► Only use the Dahl docking system if the attachments supplied by Ottobock (protective pads, edge protection)
are installed on the power wheelchair. Otherwise the belts of the occupant restraint system could become
damaged and their function could be adversely affected.
WARNING
Positioning in vehicles for transporting persons with reduced mobility
Serious injuries in case of accidents due to user error
► The positioning of the product in vehicles for transporting persons with reduced mobility may only be per­
formed by qualified personnel.
► The product must always face forwards when it is used as a seat in a vehicle for transporting persons with
reduced mobility.
► Please observe the positioning information in the instructions for use supplied by the manufacturer Dahl.
18
Description
Head support, small
Head support, large
Head support, concave, size M
Head support with ABS exterior shell, small
Head support with ABS exterior shell, large
Head/neck support, small
Head/neck support, large
Head/neck support, X-shape, small
Head/neck support, X-shape, large
Head support, concave, adjustable, one size only
Head support, 3-piece, angle-adjustable, size L
Article number
430H1=3-7
430H1=1-7
476L49=SK002
430H2=3-7
430H2=1-7
430C1=3-7
430C1=1-7
430C4=1-7
430C3=1-7
476L49=SK020
476L49=SK012
491S75=ST150, 491S75=ST155