Service And Maintenance - Festool SHINEX RAP 150 FE Manual De Instrucciones Original

SHINEX
GB
Application
Working in polish
Polishing sensitive surfaces
High-gloss polishing
Constant speed
The preselected motor speed remains con-
stant through electronic control to ensure a
uniform cutting speed even when under load.
Temperature cut-out
The machine power supply is limited and the
speed reduced if the motor exceeds a certain
temperature. The machine continues operat-
ing at reduced power to allow the ventilator to
cool the motor quickly. The machine starts up
again automatically once the motor has cooled
sufficiently.
Current limiting
Current limiting prevents permissibly high cur-
rent consumption under extreme overload,
which can lead to a decrease in the motor
speed. The motor immediately restarts after
the load is removed.
7.2 Attaching polishing pads
Only use polishing pads that are suitable for
the maximum speed specified.
The polishing pads M 14 are fitted with a
thread M 14 and are screwed directly onto the
spindle.
Procedure
Press the spindle stop
Turn the tool spindle [2-3] until the spindle
stop engages when pressed and the tool
spindle locks.
Screw the polishing pad [2-2] onto the
tool spindle or unscrew from the tool spin-
dle.
7.3 Attaching polishing accessories
StickFix is a system that simplifies the attach-
ment of polishing accessories (felt, sponge,
sheepskin) to the polishing pad [1-7] where
they are retained by an adhesive coating.
7.4 Attaching the additional handle
The additional handle [3-1] can be screwed
onto either the right or left of the gear head.
14
Adjusting
wheel set-
ting
1 - 2
3 - 4
5 - 6
[2-1].
8 Working with the machine
Observe the following instructions:
– Do not use the machine when the electron-
ics are faulty because the machine may
operate at excessive speeds. An absence of
the smooth start-up function or speed con-
trol indicates that the electronics are
faulty.
– Do not overload the machine by pressing
with excessive force! The best polishing re-
sults are achieved with moderate application
pressure. The polishing capacity and quality
are mainly dependent on the selection of the
correct polish.
– Hold the machine with two hands, one on
the motor housing and one on the gear head
or additional handle [1-6] to ensure safe
guidance.
The rubber support points on the [3-2]
provide extra stability when the machine is
set down.
9

Service and maintenance

WARNING
Risk of injury, electric shock
Always disconnect the mains plug from the
socket before performing maintenance
work on the machine!
All maintenance and repair work which re-
quires the motor housing to be opened
must only be carried out by an authorised
service workshop.
Customer service and repair
only through manufacturer or
service workshops: Please find
the nearest address at:
www.festool.com/Service
Use only original Festool spare
EKAT
4
parts! Order No. at:
www.festool.com/Service
5
3
2
1
To ensure constant air circulation, always
keep the cooling air openings in the motor
housing clean and free of blockages.
Cleaning the lint filter
Clean the lint filter [4-1]regularly on both
sides of the machine.