Metrix MTX 1032-B Manual De Instrucciones página 12

Description of MTX 1032-B (continued)
Description The MTX 1032-B probe has 2 differential channels.
A LED indicates that it is switched on.
The probe does not include its own display facilities; it is designed for
connection to the CH1 and CH2 inputs of the oscilloscope so that the
differential signal present on the +/- inputs can be viewed.
Furthermore, this probe has two switches for selecting 1/10 or 1/100 as
the attenuation coefficient.
For each differential channel, the front panel of the MTX 1032-B probe
includes:
•
•
•
This probe is a stand-alone unit powered by the 230 V
mains supply.
1. Power up the probe using the mains lead. Check that the
Functional
description
2. Connect the probe's output "I" coaxial cable to input CH1 on the
3. Connect the probe's output "2" coaxial cable to input CH2 on the
4. Connect the red banana lead to the positive input of the probe and
5. Remove the protective caps from the lead touch prods and input the
6. Select the appropriate attenuation coefficient for the signal to be
7. When the measurements are finished, disconnect the leads. Switch off
12
2 safety banana connectors for the +/- inputs
1 BNC for output to the oscilloscope
1 attenuation coefficient selection switch: 1/10, 1/100
corresponding LED comes on.
oscilloscope.
oscilloscope.
the black banana lead to the negative input of the probe.
signal to be measured.
measured (1/10 or 1/100) using the probe switch.
The signal is then displayed on the oscilloscope screen.
the probe and then disconnect the oscilloscope.
English
50 Hz / 60 Hz
AC
MTX 1032-B - MTX 1032-C