Weight Application - Snap-On EEWB334A Manual De Operador

5-17
5-18
A
1 (WAP)
5-19
1
5-20
5.8
The following weight types and application methods
are available:
-
-
After spinning the wheel look at the rotation indicators
for the left plane of the wheel
The weight to be applied in that plane is shown on the
display; the two arrows light up green.
• Turn the wheel manually until it reaches the
Arrows above and below, completely green.
CAUTION: MOVE AWAY FROM THE WHEEL
B
Attaching a clip-on weight:
Refer to Figure 5-17.
• Clip-on weights must always be applied in the 12
• The lip should rest on the rim edge. Use the weight
In STATIC mode only the left hand display is used (1,
Fig. 5-20).
Attaching a stick-on weight.
ALU or STATIC weight modes only:
Refer to Figure 5-18.
• Apply the weight on the rim in the 12 o'clock
EEWB334A

Weight Application

Clip-on weights:
Always apply by hand (Fig.
Stick-on weights:
Must be applied by hand
gauge head, for the Alu 2P, Alu 3P or HWM mode
(Up with arm, or at 5 o'clock position with Laser
Pointer)
Note: Hand applied weights must always be
applied exactly perpendicular to the shaft
(12 o'clock position).
counterweight application point.
- Alternatively, press on the value shown (A, Fig.
5-19), the motor starts the wheel until it reached
the WAP position (Arrows green).
o'clock position.
pliers to position it.
position, always by hand.
Note: With STATIC weight modes, always
apply the weight at the rim centre line.
If not possible, split the weights evenly
and apply on another surface of the rim
(symmetrical to the rim center line).
Note: With large static unbalance (e.g.>30g)
divide the unbalance into two fairly equal
parts and correct it at both sides of the
wheel, considering the chosen ALU
balancing mode.
5-17).
(Fig. 5-18), or using the
(1, Fig. 5-19):
31