Snap-On EEWB334A Manual De Operador página 43

Equilibradora de ruedas fuera del vehículo
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

26
5-49
5-50
5-51
5-52
Reading of error code E9
If E9 is read out, at least one error was made with
respect to the sequence of operations when performing
optimization (System messages
— Abort the optimization program by pressing the
STOP key and, if desired, start optimization once
again.
Fig. 5-49 OPTIMIZATION "OP.12"
(Fourth measuring run of tire/rim assembly)
Clamp the wheel on the balancer.
Rotate the wheel such that the valve is exactly
perpendicular to and above the main shaft.
Confi rm the valve position by pressing menu key
26.
The OPTIMIZATION "OP.13" screen (Fig. 5-50) is
displayed.
Fig. 5-50 OPTIMIZATION "OP.13"
START is displayed on the screen.
Spin the wheel.
A measuring run is performed.
The BALANCING screen (Fig. 5-51) is displayed.
Finish Weight Optimization
Fig. 5-51 BALANCING
— Balance the wheel according to the readings.
If the wheel running conditions are optimal, the
following codes can be displayed (Fig. 5-52):
H0 Wheel running conditions cannot be improved by
optimization.
H1 Further optimization not recommended but
feasible.
H2 Weight minimization is recommended, optimization
can achieve no further improvement.
EEWB334A
F
7.1).
43

Publicidad

Tabla de contenido
loading

Tabla de contenido