Assembly - Makita EB5300TH Manual De Instrucciones

ASSEMBLY

CAUTION:
Before performing any work
on the blower, always stop the engine and
pull the spark plug cap off the spark plug.
CAUTION:
Start the blower only after
having assembled it completely.
CAUTION:
Always wear protective
gloves.
Assembling blower pipes
1. Insert the swivel pipe into the flexible pipe
and tighten them with the hose band.
2
► 1. Swivel pipe 2. Flexible pipe 3. Hose band
2. Loosen and remove the clamp screw.
► 1. Clamp screw
For tube throttle model, be careful not to twist the
cable on the control handle when attaching to
the swivel pipe.
3. Install the control handle / handle assembly
onto the swivel pipe and tighten them with the
clamp screw.
3
1
1
► 1. Control handle / handle assembly
2. Clamp screw
4. Attach the flexible pipe to the elbow
For tube throttle model: Insert the elbow to the
flexible pipe. Attach the cable holder between
the hose band and the flexible pipe. Tighten the
cable holder, flexible pipe and elbow with the
hose band. Set the control cable onto the cable
holder, and close the cable holder.
► 1. Elbow 2. Cable holder 3. Hose band
► 1. Cable holder 2. Control cable
For hip throttle model: Insert the elbow to the
flexible pipe. Tighten the flexible pipe and the
elbow with the hose band.
5. Attach the long/short pipe to the swivel pipe. Turn
the long/short pipe clockwise to lock it into place. Then
attach the blower nozzle with the long/short pipe. Turn
the blower nozzle clockwise to lock it into place.
10 ENGLISH
1
1
3
1
2
2
2