Gree Versati III Manual Del Propietário página 30

Operation Instructions for Versati III
16 Status of other thermal source
17 Status of the 2-way valve
18 Status of antifreeze
19 Status of the door guard
20 Status of the 4-way valve
21 Status of disinfection
22 Status of the flow switch
2.5.2 Parameter Viewing
[Operation Instructions]
1. At the "VIEW" page, by touching "Parameter", it is able to view each parameter of the unit, as shown in the
figure below.
No.
1 Environmental temperature
2 Suction temperature
3 Discharge temperature
4 Defrosting temperature
5 Entering water temperature of the plate type heat exchanger
6 Leaving water temperature of the plate type heat exchanger
Leaving water temperature of the auxiliary heater
7
8 Water tank temperature
9 Floor debug target temperature
10 Floor debug runtime
11 Liquid line temperature
12 Vapor line temperature
13 Economizer inlet temperature
14 Economizer outlet temperature
15 Remote room temperature
16 Discharge pressure
17 Weather-dependent target temperature
2.5.3 Error Viewing
[Operation Instructions]
At the "VIEW" page, by touching "Error", it is able to view errors of the unit, as shown in the figure below.
Other thermal
2-way valve
HP-Antifree
Gate-Ctrl.
4-way valve
Disinfection
Flow switch
Parameter View Page
Viewable Parameters
Full Name
25
On/Off
On/Off
On/Off
Card in/Card out
On/Off
Off/Running/Done/Fail
On/Off
Displayed Name
T-outdoor
T-suction
T-discharge
T-defrost
T-water in PE
T-water out PE
T-optional water Sen.
T-tank ctrl.
T-floor debug
Debug time
T-liquid pipe
T-gas pipe
T-economizer in
T-economizer out
T-remote room
Dis. pressure
T-weather depend