Menu Operation; Fault Indications; Fault Log - Grundfos CUE 150 Instrucciones De Instalación Y Funcionamiento

10.5 Menu OPERATION

10.5.1 Setpoint (1.1)
Setpoint set
Actual setpoint
Actual value
Set the setpoint in units of the feedback sensor.
In control mode Open loop, the setpoint is set in % of the
maximum performance. The setting range will lie between the
min. and max. curves. See fig. 44.
In all other control modes except proportional differential
pressure, the setting range is equal to the sensor measuring
range. See fig. 45.
In control mode Proportional differential pressure, the setting
range is equal to 25 % to 90 % of max. head. See fig. 46.
If the pump is connected to an external setpoint signal, the value
in this display will be the maximum value of the external setpoint
signal. See section 13.2 External setpoint.
10.5.2 Operating mode (1.2)
Set one of the following operating modes:
• Normal (duty)
• Stop
• Min.
• Max.
The operating modes can be set without changing the setpoint
setting.

10.5.3 Fault indications

Faults may result in two types of indication: Alarm or warning.
An "alarm" will activate an alarm indication in CUE and cause
the pump to change operating mode, typically to stop. However,
for some faults resulting in alarm, the pump is set to continue
operating even if there is an alarm.
A "warning" will activate a warning indication in CUE, but the
pump will not change operating or control mode.
Alarm (1.3)
In case of an alarm, the cause will appear in the display.
See section 15.1 Warning and alarm list.
26
Warning (1.4)
In case of warning, the cause will appear in the display.
See section 15.1 Warning and alarm list.

10.5.4 Fault log

For both fault types, alarm and warning, the CUE has a log
function.
Alarm log (1.5-1.9)
In case of an "alarm", the last five alarm indications will appear in
the alarm log. "Alarm log 1" shows the latest alarm, "Alarm log 2"
shows the latest alarm but one, etc.
The display shows three pieces of information:
• the alarm indication
• the alarm code
• the number of minutes the pump has been connected to the
power supply after the alarm occurred.
Warning log (1.10-1.14)
In case of a "warning", the last five warning indications will
appear in the warning log. "Warning log 1" shows the latest fault,
"Warning log 2" shows the latest fault but one, etc.
The display shows three pieces of information:
• the warning indication
• the warning code
• the number of minutes the pump has been connected to the
power supply after the warning occurred.