Setting Up The Unit - NORAUTO HT7101 Instrucciones De Uso

6 VOLT / 12 VOLT SWITCH
The unit has two voltage rate settings (6v, 12v) controlled by one
switch. Set the switch to either 6v or 12v depending upon the
battery you are charging.

SETTING UP THE UNIT

Ensure that all installation and operating instructions and safety
precautions are understood and carefully followed by anyone
installing or using the Maintainer.
Follow the steps outlined in the "SAFETY PRECAUTIONS" section
of this manual.
When using this charger/maintainer in proximity to the car's battery
and engine, stand the maintainer on a flat, stable surface and be
sure to keep all clamps, eyelets, cords, clothing and body parts
away from moving parts of the car. Keep enough space around the
appliance for allowing adequate ventilation.
Incorrect connection, battery short circuit, location of battery and
location of the battery charger/maintainer may create a hazard.
Make sure that adequate preparation has been made before
proceeding.
OPERATING INSTRUCTIONS
IMPORTANT: ALWAYS disconnect the AC power
cord from the AC power outlet before connecting (or
disconnecting) the charger to (or from) the battery.
IMPORTANT: This power system is to be used ONLY
on cars with 6V DC or 12V DC battery system. Do NOT
connect to a 24V DC battery system.
125