Setting Up The Unit - NORAUTO 2222087/NO6762 Instrucciones De Uso

Understand LCD ICON
ICON

SETTING UP THE UNIT

Ensure that all installation and operating instructions and safety precautions are understood and
carefully followed by anyone installing or using the Charger.
Follow the steps outlined in the "SAFETY PRECAUTIONS" section of this manual.
When using this charger in proximity to the car's battery and engine, stand the maintainer on a flat,
stable surface and be sure to keep all clamps, eyelets, cords, clothing and body parts away from
moving parts of the car. Keep enough space around the appliance for allowing adequate ventilation.
Incorrect connection, battery short circuit, location of battery and location of the battery charger may
create a hazard. Make sure that adequate preparation has been made before proceeding.
OPERATING INSTRUCTIONS
IMPORTANT: ALWAYS disconnect the AC power cord from the AC power outlet before
connecting (or disconnecting) the charger to (or from) the battery.
IMPORTANT: This power system is to be used ONLY on cars with 6V DC or 12V DC
battery system. Do NOT connect to a 24V DC battery system.
Fault Icon
6V, 12V Charging Mode Icon
Charge Time Remain Icon
* The remaining charging time calculated basing on a 100Ah battery.
It may vary depending on the battery capacity, the condition of the
battery, ambient temperature, etc.
Digital Display by Current or Voltage
* During Charging Amp and Voltage displays alternatively for every
3 seconds
Battery Icon
Over-Heat Icon
Floating Charging mode
Alternator checking mode
Explanation
(FOR REFERNCE ONLY!!)
129