<< Operating instructions SATA filter 100/101/103 prep >>
1. Connect suitable compressed air hose.
2. Turn the pressure adjustment knob [1-5] in counterclockwise direction
to the maximum; state = closed
3. Fully open ball valve [1-6]
4. Turn pressure adjustment knob [1-5] to the right until required pres-
sure is displayed on the pressure gauge [1-3].
5. Control pressure when operating the spray gun (trigger fully pulled)
and re-adjust, if necessary.
9.
Function
9.1. Filter stage [A]:
The first filter stage separates particles > 5 µm as well as condensed wa-
ter and oil. The sintered filter (Art. No. 22160) is integrated in the filter.
Note!
Sintered filter:
• Fineness 5µm
• Surface 100 cm²
The automatic condensate drain valve [1-9] only works properly when the
filter is vertically mounted. If a certain condensate filling level is reached
inside the filter housing [1-12], the condensate drain valve opens auto-
matically draining the condensate through the condensate drain hose [1-
10] into the collection container (not included in delivery) until just a small
residual quantity remains.
9.2. Filter stage [B]:
The fine filter cartridge (Art. No. 148270) of the second filter stage
separates smallest particles.
Note!
Fine filter cartridge:
• Special micro fibre fleece
• Fineness 0.1 µm, separation degree 99.998 % related to a particle
size > 0.1 µm
• Surface 300 cm²
EN
VII.5