Installing the Battery Module
NOTE: For this procedure, refer to FIGURE 6.1 on page 20.
1.
Raise unit handle to upright position.
2.
With battery pack label facing toward the transportable oxygen
concentrator, slowly lower battery module straight down into battery
recess located on back side of the transportable oxygen concentrator.
3.
Approximately halfway down, ensure side ribs on battery module have
engaged with matching slots on back side of the transportable oxygen
concentrator.
4.
Continue lowering battery module into place, pressing firmly to ensure
contact with battery connections located on the transportable oxygen
concentrator.
NOTE: DO NOT slam or force battery module into place, damage to battery
connections may occur.
5.
Ensure battery module has engaged. Battery gauge and percentage will
no longer read zero. Refer to Checking Battery Charge Level on page 22.
Charging the Battery
NOTE: For this procedure, refer to FIGURE 6.1.
1.
To charge the battery module, make sure the module is fully seated on
the unit.
2.
Perform one of the following:
•
Connect the DC power cable (DETAIL "B").
•
Connect the AC power adapter (DETAIL "C").
3.
Turn off the unit for fastest charge time. Charging times are extended if
unit is operating.
NOTE: DC power input may not be sufficient to charge battery at all settings if
unit is operating.
NOTE: If the battery is completely discharged, it will fully charge in
approximately 4 to 5 hours. During regular use of the transportable oxygen
concentrator, it is recommended to recharge the battery, even if only partially
depleted, as often as possible.
Battery Time Management
Time away from home is almost limitless by combining the use of the AC
power supply, DC power cable and battery modules. To ensure the batteries
maintain their optimal charge level, utilize the AC power supply whenever
you have access to electric power. Utilize the DC power supply whenever
you are in a vehicle.
Part No 1163190
SECTION 6—OPERATING INSTRUCTIONS
21
Invacare SOLO
™
2