Using The Adaptive Picture Control (Apc) - Sony SVO-1630 Manual De Instrucciones

Using the Adaptive Picture Control (APC)

Adaptive Picture Control (APC) automatically improves recording and
playback quality by adjusting the VCR to the condition of the video heads
and tape. To maintain better picture quality, it is recommended to set
MENU
"APC" to ON in the SET UP menu.
CURSOR
4/$
1
Press MENU and select 4.SET UP/USED TIME, then press
EXECUTE
EXECUTE.
The SET UP menu appears.
[ SET UP ]
TIMER PB END
REPEAT MODE
APC
DISPLAY
STOP TIMER
THREAD CHECK
[ USED TIME ]
CH +/– HEAD
2
Press CURSOR 4 /$ to flash the setting of "APC".
[ SET UP ]
TIMER PB END
REPEAT MODE
APC
DISPLAY
STOP TIMER
THREAD CHECK
[ USED TIME ]
HEAD
3
Set to ON to use APC function using CH +/–, then press EXECUTE.
[ SET UP ]
TIMER PB END
REPEAT MODE
APC
DISPLAY
STOP TIMER
THREAD CHECK
[ USED TIME ]
HEAD
4
Press MENU to return to the normal display.
To use APC during playback
The APC function automatically works on all types of tapes, including
rental tapes. You can play a tape using the APC function even if the tape
was not recorded with it.
To use APC while recording
Whenever you insert a tape and first start recording, the VCR adjusts to the
tape using the APC function.
This adjustment is retained until the tape is ejected. There is a short delay
before the VCR actually starts recording while the VCR analyzes the tape.
REW
REPEAT
OFF
ON
5M
ON
00000H
REW
REPEAT
OFF
ON
5M
ON
00000H
REW
REPEAT
ON
ON
5M
ON
00000H
31
(US)