Using The Automatic Wheel Clamping System C - Corghi CompactLine Serie Manual De Uso

4. the help icon displays information on the current screen. If an error message is
displayed, the first piece of information displayed concerns the type of errors that may oc-
cur. The instructions called up by this icon integrate (but do not replace) this User Manual.
By default the icons relating to points 3 and 4 are those described above but can be replaced
with more frequently used ones (refer to the "Preferred programme configuration" section).
USING THE AUTOMATIC WHEEL
Procedure for locking the wheels with the automatic C system:
Centring with front cone
- Fit the wheel on the shaft, sliding it into place until it rests against the flange.
- Fit the most suitable cone on the shaft and insert it into the central hole of the wheel.
- Fit the locking device by making it slide on the hub until it comes into contact with the
cone.
- Press the control pedal for at least one second.
Centring with rear cone
- Fit the most suitable cone for the central hole of the wheel on the shaft.
- Fit the wheel onto the cone, sliding it into place until the cone comes into contact with
the plate that holds the spring.
- Apply the protective cap to the sleeve.
- Fit the locking device by making it slide on the hub until it comes into contact with the
wheel.
- Press the control pedal for at least one second.
Wheel release
- Press the control pedal for at least one second to release the wheel from the flange.
Centring with flanges
Operator's manual EM 9280 - EM 9280 C CompactLine
CLAMPING SYSTEM C
UK
83