Information Regarding Machine Demolition; Environmental Information - Corghi CompactLine Serie Manual De Uso

Keep the wheel balancer shaft, the securing ring nut, the centring cones and flange clean.
These components can be cleaned using a brush previously dripped in environmentally
friendly solvents.
Handle cones and flanges carefully so as to avoid accidental dropping and subsequent
damage that would affect centring accuracy.
After use, store cones and flanges in a place where they are suitably protected from dust
and dirt.
If necessary, use ethyl alcohol to clean the display panel.
Perform the calibration procedure at least once every six months.
INFORMATION REGARDING MACHINE
DEMOLITION
If the machine is to be scrapped, remove all electrical, electronic, plastic and metal parts.
and dispose of them separately in accordance with current provisions as prescribed by law.

ENVIRONMENTAL INFORMATION

The disposal procedure described below only applies to machines with the symbol of the
waste bin with a bar across it on their data plates.
This product may contain substances that can be hazardous to the environment and to hu-
man health if it is not disposed of properly.
The following information is therefore provided to prevent the release of these substances
and to improve the use of natural resources.
Electrical and electronic equipment must never be disposed of in the usual municipal waste
but must be separately collected for their proper treatment.
The crossed-out bin symbol, placed on the product and on this page, reminds the user that
the product must be disposed of properly at the end of its life.
In this way it is possible to prevent that a non specific treatment of the substances contained
in these products, or their improper use, or improper use of their parts may be hazardous to
the environment or to human health. Furthermore, this helps to recover, recycle and reuse
many of the materials contained in these products.
Electrical and electronic manufacturers and distributors set up proper collection and treat-
ment systems for these products for this purpose.
Contact your local distributor to obtain information on the collection procedures at the end
of the life of your product.
When purchasing this product, your distributor will also inform you of the possibility to return
another end-of-life piece of equipment free of charge as long as it is of equivalent type and
had the same functions as the purchased product.
124 Operator's manual EM 9280 - EM 9280 C CompactLine