Device-Specific Safety Instructions For Drill Sharpeners - Parkside PBSG 95 B1 Instrucciones De Utilización Y De Seguridad

General safety advice
C heck the condition of extension leads regular-
ly and replace them if they are damaged.
K eep handles and hand grips clean, dry and
free of oil and grease.
15. Pull the mains plug out of the mains
socket.
D o this if the electrical power tool is not being
used, before carrying out maintenance tasks
on the electrical power tool and whenever you
are changing inserted tools, e.g. saw blades,
drills or router bits.
16. Make sure that no spanners, keys etc.
are left attached.
C heck before switching on that all spanners,
keys and setting tools have been removed.
17. Avoid unintentionally starting up the
device.
C heck that the switch is set to OFF on the de-
vice when the mains plug is inserted into the
mains socket.
18. Using an extension lead for working
outdoors.
W hen working outside, always use an approved
and appropriately labelled extension lead.
19. Remain alert.
W atch what you are doing. Proceed with cau-
tion. Do not use electrical power tools if you
cannot concentrate.
20. Check the electrical power tool for
damage.
B efore the electrical power tool is used, carefully
check the safety equipment and any slightly
damaged parts to see that they are still work-
ing properly.
C heck that all moving parts on the tool are
working properly, can move freely and are not
damaged. All parts must be correctly attached
and fulfil all the requirements necessary to allow
the electrical power tool to operate properly.
D amaged safety equipment and components
must be properly repaired or replaced at a
competent electrical equipment repair centre
unless otherwise indicated in the operating in-
structions.
D amaged switches must be replaced at a
Customer Service Centre.
N ever use an electrical power tool that cannot
be switched on and off properly.
32 GB/MT
21. CAUTION!
T he use of inserted tools and accessories other
than those recommended by the manufacturer
could lead to you being injured.
22. Have your electrical power tool
repaired at an electrical equipment
repair specialist.
T his electrical power tool complies with the
relevant safety regulations. Repairs may only
be carried out by a specialist electrical repair
centre using original spare parts, otherwise
injury could occur to the user.
D evice-specific safety instruc-
Q
tions for drill sharpeners
M ake sure that the device is switched
off before inserting the mains plug
into the socket.
A lways pull the mains plug out before
carry out cleaning or maintenance work.
This is to prevent the device starting up by accident.
T he ventilation openings
tor unit must always be kept clear.
Otherwise there is a risk of the device overheating.
W hen carrying out work on the device
as well as transporting or storing it,
move the ON / OFF switch
"0" position (off) in order to prevent
it switching itself on by accident.
FIRE HAZARD DUE TO FLYNG SPARKS!
Grinding metal will cause sparks to fly. That is
why you should always make sure that no-one
is at risk from them and that no combustible
materials are located in the proximity of the
area of work.
RISK OF INJURY! Use the
ON / OFF switch
4
in the event of a power failure or when pulling
out the mains plug. This prevents the grinder restart-
ing by accident, which could cause injury to you.
N ever operate the grinder if the power
cable or mains plug is damaged.
G rinding stones must be carefully
stored and handled according to the
manufacturer's instructions.
of the mo-
10
to the
4
to switch the grinder off