Hatco FLAV-R-SAVOR FSD Serie Manual De Instalación Y Funcionamiento página 11

Ocultar thumbs Ver también para FLAV-R-SAVOR FSD Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
WARNINGS (CONTINUED)
To avoid electrical shock or personal injury, do not
steam clean or use excessive water on the unit.
Some exterior surfaces on the unit will get hot. Use
caution when touching these areas to avoid injury.
Only light bulbs which meet or exceed N.S.F.
standards, specifically designed for food holding areas
must be used. Breakage of light bulbs not specially
coated or covered could result in personal injury and/or
food contamination.
Be sure the protective lens cover for the light bulbs are
installed. Breakage of a bulb not properly covered
could
result
in
personal
contamination.
Unit is not waterproof. DO NOT submerge in water. Do
not operate if it has been submerged in water.
Do not lay unit on the side with the control panel or
damage to the unit could occur.
To avoid any injury, turn the power OFF to the unit and
allow to cool before draining.
To prevent any injury or damage to the unit do not pull
unit by power cord.
To prevent any injury, discontinue use if power cord is
frayed or worn.
Units with a motorized rotating style display use safety
door switches that turn the rotating rack off when a
door is opened. If the rack rotates when a door is
opened, unplug the unit and contact your Authorized
Service Agent for service.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the Hatco
Service Department at 414-671-6350; International fax
414-671-3976.
This product has no "user" serviceable parts. To avoid
damage to the unit or injury to personnel, use only
Authorized Hatco Service Agents and Genuine Hatco
Parts when service is required.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement Parts
may subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
IMPORTANT SAFETY INFORMATION
injury
and/or
food
9
CAUTIONS (CONTINUED)
The National Sanitation Foundation (NSF) requires that
units over 914 mm (36") in length or weighing more
than 36 kg (80 lbs.) to be either sealed or raised on the
installation surface. If this unit cannot be sealed at the
point of use, 102 mm (4") legs are included to allow for
proper cleaning access below unit.
Unit is not weatherproof. For safe and proper operation
the unit must be located indoors where the ambient air
temperature is a minimum of 21°C (70°F) and a
maximum of 29°C (85°F).
CAUTIONS
Use only non-abrasive cleaners. Abrasive cleaners
could scratch the finish of your unit marring its
appearance and making it susceptible to soil
accumulation.
Water Quality Requirements - Incoming water in excess
of .75 grains of hardness per liter (3.0 grains of
hardness per gallon (GPG)) must be treated and
softened before being used. Water containing over
.75 GPL (3.0 GPG) will decrease the efficiency and
reduce the operating life of the unit.
Form No. FSDCEM-0805

Publicidad

Tabla de contenido
loading

Tabla de contenido