Removing Lime & Mineral Deposits; Accessories - Hatco FLAV-R-SAVOR FSD Serie Manual De Instalación Y Funcionamiento

REMOVING LIME & MINERAL DEPOSITS
CAUTION
Water Quality Requirements - Incoming water in excess of
.75 grains of hardness per liter (3.0 grains of hardness per
gallon (GPG)) must be treated and softened before being
used. Water containing over .75 GPL (3.0 GPG) will
decrease the efficiency and reduce the operating life of the
unit.
NOTE: Product failure caused by liming or sediment buildup is
not covered under warranty.
NOTE: If the water used has an excessive amount
of lime or mineral content, follow the instructions listed below
for periodic cleaning and deliming of the water reservoir.
1. Turn the power switch off and unplug the unit from its power
source.
2. After the unit has cooled down, drain all remaining water
out of the unit. See DRAINING THE RESERVOIR.
3. Fill the unit with a mixture of water and delimer.
NOTE: The delimer used should be a safe, non-toxic, non-
corrosive solution. Follow the delimer's instruction for proper
mixture of water and delimer solution.
4. Allow the unit to stand with the mixture in the reservoir for
the recommended period of time. (The time required will
vary depending on the solution used and amount of
deposits in the reservoir.)
5. After the deliming period, drain the solution from the tank.
STACKING KIT
Special brackets are available for stacking one unit on top of
another. This stacking hardware secures the top unit to the
lower unit. Holes must be drilled into both units and brackets
attached using hardware supplied. See 11 .
ADJUSTABLE LEGS
102 mm (4") adjustable legs are available for the units. Legs
mount in holes at bottom corners of cabinet. See 12 .
MERCHANDISING DISPLAY SIGN
Merchandising Display Signs, which include the metal holder,
acrylic window and printed sign are available to promote Pizza,
Chicken or Fish food products. Install holder on one of three
sides of the cabinet top.
1. Remove the existing screws securing the top cover in
place, position the sign holder over the screw holes and
reinstall the screws. See 13 .
2. Place the printed sign in the holder and slide the protective
acrylic window over the sign.
MERCHANDISING FOOD GRAPHICS
Graphic decals feature food illustrations only and are available
for Pizza, Chicken, Pretzel and Croissant/Biscuits. Install
decals on three sides of the cabinet above the glass panels.
1. Clean the stainless steel side panels with a non-oily
cleaner, such as isopropyl alcohol (rubbing alcohol).
2. When sides are dry, simply remove the protective backing
from the decal and apply to the panel.
6. Continue to fill and drain the unit with water only, until the
discharge is clear and all deliming solution has been
removed and rinsed.
7. Plug the cabinet power cord into its power source and fill
the unit as usual for daily operation.
NOTE: How often this procedure must be performed depends
on the lime and mineral content of the water used for daily
operation.
If service is required on this unit, contact your Authorized
Hatco Service Agent, or contact the Hatco Service
Department at 414-671-6350;
414-671-3976.
This product has no "user" serviceable parts. To avoid
damage to the unit or injury to personnel, use only
Authorized Hatco Service Agents and Genuine Hatco Parts
when service is required.
Genuine Hatco Replacement Parts are specified to operate
safely in the environments in which they are used. Some
aftermarket or generic replacement parts do not have the
characteristics that will allow them to operate safely in
Hatco equipment. It is essential to use Hatco Replacement
Parts when repairing Hatco equipment. Failure to use
Hatco Replacement Parts may subject operators of the
equipment to hazardous electrical voltage, resulting in
electrical shock or burn.
3. Remove air pockets by rubbing gently with a soft cloth from
the center towards the outer edges.
PANS
Aluminum half-size bun pans 457 x 330 mm (18" x 13") are
available for the stationary style racks.
Aluminum Pizza pans are available in 356 mm (14"), 381 mm
(15"), 406 mm (16") and 457 mm (18") diameters which fit all
of the rotating style racks.
DISPLAY RACKS
A wide assortment of plated racks are available to "customize"
the Flav-R-Savor to your foodservice operation.
FSD Only (See 14 )
5-Shelf Multi-Purpose Rack, Model - FS5SMPACC
3-Tier Circle Rack, Model - FSD3TCRACC
3-Tier Pan Rack, Model - FS3TPRACC‡
FSDT Only (See 15 )
7-Shelf Multi-Purpose Rack, Model - FST7SMPACC
4-Tier Circle Rack, Model - FSDT4TCRACC
5-Tier Circle Rack, Model - FSDT5TCRACC
4-Tier Pan Rack, Model - FST4TPRACC‡
3-Shelf Angle Rack, Model - FST3SARACC
5-Shelf Angle Rack, Model - FST5SARACC
3-Tier Pretzel Tree, Model - FSDT3TPTACC
‡ Accommodates half-size bun pans, not included.
DESIGNER COLORS
Choose from warm red, black, gray granite, white granite,
hunter green or navy blue powdercoated cabinet colors to
blend into any decor. Only available at time of purchase.
15
MAINTENANCE
WARNING
International
WARNING
WARNING

ACCESSORIES

Form No. FSDCEM-0805
fax