Output Data Section In The Controller - Aventics DDL Serie, CL03 Serie Instrucciones De Servicio

Table 10: Assignment of the output bits for double solenoid valves
1)
Byte Applies to
X Valve
Solenoid
X+1 Valve
Solenoid
X+2 Valve
Solenoid
X+3 Valve
Solenoid
1)
Byte X is the start address for the output section of this module in the controller.
AVENTICS | DDL, CL03/CL03-XL | R402003658–BDL–001–AE
Table 9: Output data length on the S6 switch, bits 3 and 4
Data length
1 byte
2 byte
3 byte
4 bytes (default)
Changes are only taken over after a voltage reset. After
making changes, turn the DDL line supply voltage off and
then on again.

7.1.4 Output data section in the controller

The DDL address determines the position of the output data in
the data range of the bus coupler, and thus the position in the
address range in the controller.
If the address 0 (automatic addressing) is set, the VS will act like
a valve unit.
The valve system occupies 1 to 4 bytes in the output section of
the controller, depending on the set length.
The following table shows the assignment of the output bits to
the valves and solenoids.
Bit 7 Bit 6 Bit 5
4 4
12 14 12
8 8
12 14 12
12 12 11
12 14 12
16 16 15
12 14 12
The valve system does not occupy any data in the input section
of the DDL, but does in the diagnosis area.
Commissioning and Operation
Valve
S6, Bit 3
solenoids
8 OFF
16 ON
24 OFF
32 ON
Bit 4 Bit 3
3 3 2
14 12
7 7 6
14 12
11 10
14 12
15 14
14 12
S6, Bit 4
OFF
OFF
ON
ON
Bit 2 Bit 1 Bit 0
2 1
14 12 14
6 5
14 12 14
10 9
14 12 14
14 13 13
14 12 14
71
1
5
9