Acknowledging Errors - salmson SIE Serie Instrucciones De Instalación Y Funcionamiento

English
Grouping No.
E075 Charging relay defec-
E076 Internal transformer
E077 24 V operating voltage
Impermissi- E099 Type of pump
ble combina-
torics
11.3

Acknowledging errors

General
6.0.0.0
E000
6.0.0.0
10
1/1
Fig. 40: Navigation in case of error
80
Error
tive
defective
for sensor defective
- +
E000
5.0.0.0
S
Possible cause Remedy
In the event of an error, the error page is displayed instead of the sta-
tus page.
Generally in this case, navigation can be done this way (Fig. 40):
• To change to the menu mode, press the acknowledge button.
The menu number <6.0.0.0> flashes.
By pressing a tuning button, it is possible to navigate in the menu as
usual.
• Press the acknowledge button.
The menu number <6.0.0.0> is displayed statically.
On the units display, the current incidence (x) as well as the maximum
incidence of the error (y) are displayed in the format "x/y".
As long as the error cannot be acknowledged, pressing the acknowl-
edge button again will cause a return to the menu mode.
NOTE
A time-out of 30 seconds leads back to the status page or the error
page.
NOTE
Every error number has its own error meter, which counts the inci-
dence of the error within the last 24 h and is reset after manual
acknowledgement, 24 h continuous "mains on" or a new "mains on".
Error type
HV AC
A A
A A
A A
A A
04/2009