Unpacking; Assembly (S 45 Tl Gp Only) - SICE S 45 TL Manual De Instrucciones

ENGLISH • Instructions manual

6.2 UNPACKING

1 - Remove the tyre changer from the packing and check to make sure that the machine is in a perfect condition. Make sure that there are
no visibly damaged parts.
2 - Remove all the screws that fix the machine to the pallet, using a N° 13 setscrew wrench.
3 - Slide the tyre changer sideways from the pallet with the greatest care.
N.B.: Keep the packing material out of the reach of children as it can be a source of danger.
Take the packing materials to an appropriate solid waste disposal pick up point if they are polluting or non-biodegradable.
6.3 ASSEMBLY (S 45 GP TL ONLY)
FITTING THE TANK:
1) Remove the four 8x16 bolts already fitted into the tank fixing holes on
the machine body.
1
2) Fit the elbow (3, Fig. C1) onto the valve (1, Fig. C1) sticking out of the
2
back of the machine body and fix it with the spin (2, Fig. C1).
3) Fit the tank on the body and secure it with the four TE M 8x16 bolts
removed earlier
3
C1
FITTING THE TOOL BOX:
1) Fix the supporting upright (4, Fig. C2) by fitting the screws (5, Fig. C2)
into the holes provided in the rear of the tyre changer.
2) Fix the tool box with readout unit (5, Fig. C3) to the supporting upright
(4, Fig. C3) using the screws (6, Fig. C3).
5
3) Fit the 2 hoses (7-8, Fig. C2) leading out of the readout unit into the
8
hole provided in the back of the tyre changer (see Fig. C2).
7
4) Open the tyre changer's left-hand side panel.
4
5) Inside the tyre changer there are 2 hoses leading from the inflation device,
already fitted with snap connectors.
C2
Connect the hose (7, Fig. C2) labelled "A" to the corresponding hose (9,
5
8
7
6
4
9
10
C3 C4
S 45 TL
26