Menu Navigation - Franklin Electric SUBMONITOR CONNECT Manual De Instalación Y Funcionamiento Del Propietario

INSTALLATION AND SETUP
Start-Up Programming

Menu Navigation

Press ESC to go back a level when in the programming menu. ESC
can be pressed repeatedly to get to the Home display.
NOTE: The UP button can also be used to cycle through the
displays.
Note: The FE Connect Mobile Application can also be used to
adjust SubMonitor Connect programmed operating features. Refer
to "FE Connect Mobile App" on page
If you wish to make programming changes, press the DOWN arrow
from the Home display until you see the desired programming
menu Basic Setup or Advanced Setup in the display.
1. Press ENTER to go into the sub-menus.
2. Pressing the DOWN button cycles you through the available
sub-menus. When the desired sub-menu is displayed, press
ENTER to view the current setting. Press ENTER again to change
the parameter. You will notice a blinking cursor indicating
that the parameter is able to be changed.
3. Use the UP and DOWN arrow buttons to view the available
choices. For parameters that contain numerical data, use the
UP or DOWN button to adjust the number in that position. Use
the SHIFT button to move the cursor one position to the left.
4. When the parameter setting is satisfactory, press the ENTER
button to save the setting in SubMonitor Connect memory.
5. Use the ESC button to back up one menu level or to cancel
editing a parameter.
16
35.