Installation And Setup; Installation Process - Franklin Electric SUBMONITOR CONNECT Manual De Instalación Y Funcionamiento Del Propietario

INSTALLATION AND SETUP

Installation Process

Refer to the following table when planning the installation of the SubMonitor Connect Component Relay,
Starter, or Soft Starter.
1
Plan System Identify
Goals Options
Intended Function Standard
Protection
• Tank level
maintenance • Temperature
• Irrigation
• De-watering
Hardware
Application
• Over current and
• Three phase
• Submersible
• Motor winding
• Surface pump
• Specialized pump
• Phase reversal
types
• Unbalanced
• Dry pump
1. The planned usage of the overall system determines which options and control methods are appropri-
ate, as well as how the SubMonitor Connect should be installed and programmed. Refer to
on page 27 for examples of how the system might be used.
2. System options define and automate features that support the intended operation. These features may
require specialized control methods and programming. For more details, refer to
on page 27, and "Protection Features" on page
3. The SubMonitor Connect supports many different methods for pump operation. Refer to
Functions" on page 27
4. The overall function of the system directly affects where and how the SubMonitor Connect should be
mounted. Refer to "Physical Installation" on page 10
5. The selected motor application, along with the control method(s), determines how the SubMonitor
Connect should be connected. Refer to
6. The SubMonitor Connect can be quickly and easily programmed for most standard operations. Refer to
"Start-Up Programming" on page
adjustments to achieve the desired performance.
2
Select Control
Methods
Hand/Off/Auto
• Panel mounted
Communications
• PT100/1000
• Remote
• SubTemp
monitors
(Model 6111
• Computer
only)
control
• Irrigation
over voltage
system
• BMS/PLC
insulation check
Switches
• Pressure
• Float
current and
• On/Off
voltage
protection
31.
for possible monitoring setups.
"Electrical Installation" on page 11
15. Advanced features or options may require additional parameter
3 4
Install Hardware Install Wiring
Location
• Inside
• Outside
Climate control
• Temperature
• Moisture
Distance
• Wire sizes
Measurements
• Clearance
• Drilling
for guidelines.
for more information.
INSTALLATION AND SETUP
Installation Process
5
Program
Parameters
Conduit Basic
• Routing • Application
• Separation • Motor ratings
• Limits
High Voltage
I/O setup
• Grounding
• Inputs • Input functions
• Output
Control circuits
functions
• Switched
• Scaling
inputs
Option settings
• Voltage inputs
• Programmable • Enable features
outputs • Set targets
• Communication
"Operation"
"Control Functions"
"Control
6
9